Service manual
Table Of Contents
- CONTENTS
- TO SERVICE PERSONNEL
- FRONT PANELS
- REAR PANELS
- REMOTE CONTROL PANELS
- SPECIFICATIONS
- INTERNAL VIEW
- SET MENU TABLE
- SERVICE PRECAUTIONS
- DISASSEMBLY PROCEDURES
- UPDATING FIRMWARE
- SELF-DIAGNOSTIC FUNCTION
- Starting Self-Diagnostic Function
- Starting Self-Diagnostic Function in the protection cancel mode
- Canceling Self-Diagnostic Function
- Display provided when Self-Diagnostic Function started
- Display during Self-Diagnostic Function operation
- Operation procedure of Main menu and Sub-menu
- Functions in Self-Diagnostic Function mode
- Initial settings used to start Self-Diagnostic Function
- Details of Self-Diagnostic Function menu
- 1. DSP THROUGH
- 2. RAM THROUGH
- 3. PRO LOGIC / Neo:6
- 4. MIC CHECK
- 5. VFD CHECK
- 6. MANUAL TEST
- 7. RS-232C
- 8. FACTORY PRESET
- 9. AD DATA CHECK
- 10.IF STATUS (Input function status)
- 11.DOCK CHECK
- 12.XM CHECK
- 13.DAB CHECK
- 14.HDMI AUDIO
- 15.HDMI INFORMATION
- 16.HDMI SELECT
- 17.VIDEO CONVERSION
- 18.MODEL
- 19.VERSION/CHECK SUM
- 20.DATE
- 21. DSP CHECK
- DISPLAY DATA
- IC DATA
- BLOCK DIAGRAM
- PRINTED CIRCUIT BOARDS
- PIN CONNECTION DIAGRAMS
- SCHEMATIC DIAGRAMS
- REPLACEMENT PARTS LIST
- REMOTE CONTROL
- Adjusting the system parameters
YSP-500/HTY-750
23
YSP-500/HTY-750
Change OFF to ON
OFF → ONに変更します
5. Connect the power cable of main unit to the AC outlet.
While pressing the “VOL+” key and “VOL-” key of the
main unit, press the “STANDBY/ON” key of the remote
control to activate the self-diagnostic function.
a.
Using the “UP” or “DOWN” key of the remote control,
select the self-diagnostic function menu in the figure
below.
5. 本機の電源コードをACコンセントに接続し、本機の
“VOL+”キーと“VOL-”キーを押しながら、リモコンの“電
源”キーを押し、ダイアグを起動します。
a. リモコンの“UP”キーまたは“DOWN”キーを使い、下
図のダイアグメニューを選択します。
b. リモコンの“LEFT”キーまたは“RIGHT”キーを使い、
下図のダイアグメニューを選択します。
b.
Using the “LEFT” or “RIGHT” key of the remote
control, select the self-diagnostic function sub-menu
in the figure below.
c. リモコンの“決定”キーを使い、下図のように変更し
ます。すると、ファームウェアの書き込みが開始さ
れます。
c.
Using the “ENTER” key of the remote control,
change setting as shown below. Writing of the
firmware is started.
6. プログラムの送信が終了すると、以下の画面が表示され
ます。
6. When the program transmission is completed, the
screen appears as shown below.
TxTestCh [---]
T1 Write [OFF]
T1 Write [ON ]