User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
61
tuning, since sound pressure level calculations at axis points are computed based on the summing of energy,
peaks/dips from interference are not corrected. Note 2: Delay is not tuned automatically. All the delays are set to 0
ms after auto tuning.)
• In the level adjusting, Y-S
3
first decides the necessary output power for each speaker referring to the required SPL.
Then, Y-S
3
decides the attenuation level to adjust the necessary power difference between the speakers in one
speaker array. Finally, Y-S
3
decides the input signal level from the necessary output power and amplifier gain.
Manual Development Group
© 2014 Yamaha Corporation
Published 05/2018 YJ-A2
Yamaha Pro Audio global website
https://www.yamaha.com/proaudio/
Yama
ha Downloads
https://download.yamaha.com/