User Manual

Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
44
• Adjusting distributed speaker parameters (Speaker Property - Property)
Adjust the parameters for the currently selected distributed speaker. To reflect the settings in calculation results, click
.
You can change the name of the installation plane in the “Speaker Name” text box in the upper area of Speaker
Property.
Installation plane properties
Speakers
Click to add a speaker at the center of a plane. Enter the coordinates and other parameters as necessary.
Click to display the Add Speakers window and replace all speakers and planes.
Plane Geometry
Enter the defining parameters for the plane you want to place.
Position
Enter the coordinates of the center of the plane. Default settings are x = 0.00, y = a figure determined by room shape,
z = receiving surface + 8.00. The value can be set in the range of -99.99 m to 99.99 m (-328.0 ft to 328.0 ft).
Plane Size
Enter the size of the plane. Default settings are L = 10 m, W = 10 m. The value can be set in the range of 1.00 m to 90.00
m (3.3 ft to 295.3 ft).
Plane condition
Select the reflectance of the wall surface (Hard: 100%, Medium: 50%, Transparent: 0%). You can set this parameter
to “Hard” or “Medium” to take the effects of rising acoustic pressure into consideration when placing speakers close
to a plane However, this calculation will not take sound from speakers in installed on this plane into effect.
Angle
Enter the angle of the plane. You can set Pan, Tilt and Rot. The value can be set in the range of -180.0 to 180.0.
Speaker Layout
Displays the speaker installation method and layout.