User Manual
Table Of Contents
- System Requirements
- Installation
- Installing Speaker Data
- Uninstalling
- Table of Contents
- 1. Y-S3 General Operation
- 2. Constructing the Room Shape & Audience Area
- 3. Editing Project Properties
- 4. Placing Speakers
- 5. Adjusting Speaker Parameters
- 5-1. Speaker Arrays
- 5-2. Distributed Speakers
- 6. Displaying Calculation Results
- 7. Simulation Results Report
- 8. Exporting Configurations in DME Designer Format
- 9. Other Functions
- 10. General Theory
Yamaha Sound System Simulator Y-S
3
Owner’s Manual V3.1
41
Service Area Selection
Select the area to be served by the currently selected speaker array by dragging on the audience area with the mouse.
You can also type the coordinates in the boxes. The selected area turns to a lighter color even when outside of the
audience area is selected, but only the area within the audience area will be used for the calculation. Stage, wall or
outside of the floor will not be used. This diagram shows an example of a configuration which has been made taking
account of the service area of mirrored speaker arrays installed in the y-z plane. An error message appears if the area
you designate is too small or does not match the conditions of the array speakers.
Required SPL
Enter the overall sound pressure level necessary at the target point of each single speaker. The level can be set in the
range of -50 to 200 dB. If the sound pressure required is too large for the system, you may not be able to meet the
required sound pressure levels.
EQ Tuning
Check this checkbox to adjust EQ.
Fixed Input Signal Level
Place a check in this checkbox to lock the input level for the selected speaker array outputs (Input Levels in the Config
view), and input a setting. The level can be set in the range of -10.0 to 24.0 dBu.
Enter the calculation conditions, and press to calculate the results and update the Property and Config views
in Speaker Property.
The following diagrams depict the differences before and after auto-tuning speaker arrays (included mirrored
speaker arrays) in area setting above.