User Manual

37 CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
Reference
Performances
Editing Performances
Common Edit Area
01: Chorus Effect
02: Reverb Effect
03: General
04: Name
Part Edit Area
01: Play Mode
02: Filter/EG
03: Effect-A
04: Effect-B
05: Controller
06: Receive Switch
Master Keyboard Area
Job Area
01: Recall
02: Copy
03: Bulk
Store Performance Function
Compare Performance Function
File Area
01: Save
02: Load
03: Rename
04: Delete
05: Format
06: Memory Info
Utility Area
01: General
02: MIDI
03: Controller
04: MasterComp
05: Master EQ
06: Panel Lock
Utility Job Area
01: Factory Set
02: Version
Appendix
3 Name
This parameter is used to enter a new name (between the square brackets) for the file. Move the
flashing cursor within the name field using the [l] and [r] buttons, and change the character at
each position using the [-1/NO] and [+1/YES] buttons or the Data Dial. Files can be named using
alphanumeric characters and symbols, and they can be up to eight characters long. When you
have finished entering a name, press the [ENTER] button to proceed.
4 Are you sure?
This message is displayed before executing the Rename function. Press the [+1/YES] button to
rename the file. Alternatively, press the [-1/NO] button to return to the previous screen.
04: Delete
Using the Delete function, you can remove files from the root directory of a USB flash-memory
device.
NOTE Before carrying out the steps described below, ensure that the USB flash-memory device is plugged
into the instrument’s [TO DEVICE] USB terminal. If this is not the case, the instrument will display the
message “USB device not ready” instead of the Delete screen.
NOTE The Delete function can only be used with All-type files located in the USB flash-memory device’s root
directory. If no such file exists in the root directory, the instrument will display the message “File not
found” instead of the Delete screen.
NOTE The File menu is the first screen displayed when the [FILE] button is pressed.
NOTE Before executing File functions, the instrument will display the Confirmation popup to confirm that you
wish to proceed (“Are you sure?”). You can press the [+1/YES] button to execute the File function or the
[-1/NO] button to return to the previous screen without doing so.
The following screenshots illustrate a typical example of deleting.
04: Delete selected in Step 2:
File for deletion selected in Step 3:
Confirmation popup from Step 4:
1 Delete
This shows that you are on the Delete screen.
2 File
This parameter is used to select the file to be deleted. Only All-type files located in the USB flash-
memory device’s root directory can be selected here. Use the [-1/NO] and [+1/YES] buttons or the
Data Dial to select the file you wish to delete, and then press the [ENTER] button.
Procedure 1. Press the [FILE] button.
2. On the File menu, use the [d] and [u] buttons to select 04: Delete, and then press the
[ENTER] button.
3. Use the [-1/NO] and [+1/YES] buttons or the Data Dial to select the file to be deleted, and then
press the [ENTER] button.
4. When the Confirmation popup is displayed, press the [+1/YES] button to delete the file.
FILE
W04:Delete
Press the [ENTER] button.
FILE
Delete
File
RSTAGE_01
1 2
Press the [ENTER] button.
Are you
[NO]
sure?
/[YES]
3