User Manual

36 CP4 STAGE/CP40 STAGE Reference Manual
Design of the CP4 STAGE & CP40 STAGE
Reference
Performances
Editing Performances
Common Edit Area
01: Chorus Effect
02: Reverb Effect
03: General
04: Name
Part Edit Area
01: Play Mode
02: Filter/EG
03: Effect-A
04: Effect-B
05: Controller
06: Receive Switch
Master Keyboard Area
Job Area
01: Recall
02: Copy
03: Bulk
Store Performance Function
Compare Performance Function
File Area
01: Save
02: Load
03: Rename
04: Delete
05: Format
06: Memory Info
Utility Area
01: General
02: MIDI
03: Controller
04: MasterComp
05: Master EQ
06: Panel Lock
Utility Job Area
01: Factory Set
02: Version
Appendix
03: Rename
The Rename function is used to rename files that have been saved to a USB flash-memory device.
File names containing non-English characters may not be displayed correctly by the stage piano. In
such a case, this function provides a convenient means of changing these names.
NOTE Before carrying out the steps described below, ensure that the USB flash-memory device is plugged
into the instrument’s [TO DEVICE] USB terminal. If this is not the case, the instrument will display the
message “USB device not ready” instead of the Rename screen.
NOTE The Rename function can only be used to rename All-type files located in the USB flash-memory
device’s root directory. If no such file exists in the root directory, the instrument will display the message
“File not found” instead of the Rename screen.
NOTE The File menu is the first screen displayed when the [FILE] button is pressed.
NOTE Before executing File functions, the instrument will display the Confirmation popup to confirm that you
wish to proceed (“Are you sure?”). You can press the [+1/YES] button to execute the File function or the
[-1/NO] button to return to the previous screen without doing so.
The following screenshots illustrate a typical example of renaming.
03: Rename selected in Step 2:
File for renaming selected in Step 3:
File name entered in Step 4:
Confirmation popup from Step 5:
1 Rename
This shows that you are on the Rename screen.
2 File
This parameter is used to select the file to be renamed. Only All-type files located in the USB flash-
memory device’s root directory can be selected here. Use the [-1/NO] and [+1/YES] buttons or the
Data Dial to select the file you wish to rename, and then press the [ENTER] button.
Procedure 1. Press the [FILE] button.
2. On the File menu, use the [d] and [u] buttons to select 03: Rename, and then press the
[ENTER] button.
3. Use the [-1/NO] and [+1/YES] buttons or the Data Dial to select the file to be renamed, and
then press the [ENTER] button.
4. Use the [-1/NO] and [+1/YES] buttons or the Data Dial to enter a new file name, and then
press the [ENTER] button.
5. When the Confirmation popup is displayed, press the [+1/YES] button to rename the file.
FILE
W03:Rename
Press the [ENTER] button.
FILE
Rename
File
RSTAGE_01
1 2
Press the [ENTER] button.
FILE
Rename
Name
[STAGE_04]
3
Press the [ENTER] button.
Are you
[NO]
sure?
/[YES]
4