Specifications

Page 4
3. Align the hole in the shock tower with the hole
in the cross frame as indicated in yellow. If
needed, use a screwdriver to align the hole.
4. Insert the Original Bolt from the upper portion
of the shock into the aligned hole.
5. Insert a marking device through the thru holes
in the shock tower as shown. Mark a drill loca-
tion on the side of the cross frame.
6. Remove the bolt and shock tower from the
cross frame.
7. Use a center punch and to mark the location of
the hole.
8. Wearing safety glasses, drill a 1/8”-3/16” pilot
hole through the cross frame at the marked lo-
cation.
9. Drill a 13/32” hole through the pilot hole.
10. Reinsert the shock tower into the cross frame.
Align mounting holes.
11. Install the shock tower by using the Origi-
nal Hardware from the upper portion of
the shock (yellow arrow) and (1) 10mm x
70 Hex Head Bolt, (2) 10mm Flat
Washers and (1) 10mm Nylock Nut (red
arrow).
12. Repeat Steps 1-11 for the driver side
shock tower.
13. Position the new BMF A-arm assembly in
front of the cart with the RHOX plate
facing forward.
14. Loosen the (4) bolts
on the mounting arms
of the A-arm assembly
for easier alignment.
15. Slightly spread the
mounting tabs on the
frame if needed for
installation.
Page 9
Head Bolt and (1) 12mm Nylock Nut (yellow arrow). Do not tighten.
15. Install the bracket to the chassis using (1) 10mm x 70 Hex Head
Bolt, (2) 10mm Flat Washers and (1) 10mm Nylock Nut (blue arrow).
16. Tighten both sets of hardware from steps 14 and 15.
NOTE: For matching bolt heads in the bagwell area, a second set of
10mm hardware is included in the BMF lift kit. Repeat steps 10-11
for the passenger side if desired. This will not effect the lift kit.
17. Reinstall the connecting rod to the new bracket and the original
mounting tab using the Original Hardware.
18. Tighten any hardware left loose in this section.
19. If the cart is not high enough to accommodate the larger tires and
wheels, raise the cart to the correct height with the jack.
20. Install the (2) rear tires/wheels on the rear hubs.
21. Remove the jack stands and lower the cart.
22. Remove the jack.