Owner`s manual

3-15
E
1) If there is an air vent screw on the fuel
tank cap, loosen it 2 or 3 turns.
902053
25-3/30
304024*
001671
902061
25
N
406012
3) Squeeze the primer bulb with the out-
let end up until you feel it become
firm.
2) If there is a fuel joint on the motor,
firmly connect the fuel line to the
joint. Then firmly connect the other
end of the fuel line to the joint on the
fuel tank.
NOTE:
During engine operation place the tank
horizontally, or fuel cannot be drawn into
the engine.
EMU01497
PROCEDURE FOR TILLER CONTROL
MODEL
4) Place the gear-shift lever in the neu-
tral position.
NOTE:
The start-in-gear protection device pre-
vents the engine from starting except
when in Neutral.
6L2-9-1K-3 2/17/03 18:40 Page 16