Service manual

HULL
HOOD
Hull and hood
8-21
Seat lock check
1. Check the seat lock assy. Replace if
cracked, damaged, or worn.
2. Check the projection. Replace if dam-
aged.
Check valve check
1. Blow into the end “A” of the check valve,
and make sure that airflow from the end
“B” is unrestricted. Replace if the air flow
is restricted.
2. Blow into the end “B” of the check valve,
and make sure that airflow from the end
“A” is restricted. Replace if the air flow is
unrestricted.
Water separator assy. removal
1. Make a mark a on the fuel tank breather
hose 1 1.
2. Disconnect fuel tank breather hose 1 1
and fuel tank breather hose 2 2.
Water separator check
1. Check the water separator 1, O-ring 2,
and drain plug 3. Replace if cracked or
damaged.
Water separator assy. installation
1. Connect fuel tank breather hose 1 1 and
fuel tank breather hose 2 2 onto the
water separator 3.
TIP:
Connect fuel tank breather hose 1 1, which
is identified by the mark a, to the water sep-
arator outlet with the arrow mark b.
Cooling water pilot outlet installation
Do not reuse a seal, always replace it with
a new one.
1. Install a new seal 1 and the cooling
water pilot outlet 2, and then tighten the
nut 3 to the specified torque.
1
2
a
1
2
3
b
1
2
3
a