Service manual

HULL
HOOD
Hull and hood
8-17
Steering cable installation (steering
master end)
If a cable becomes damaged, replace it.
Never attempt to repair damaged cable.
1. Install the steering cable 1 and steering
cable stopper 2, and then tighten the
bolt 3 to the specified torque.
TIP:
Install the steering cable stopper 2 into the
groove a in the outer cable.
2. Connect the steering cable joint 4 to the
ball joint 5.
3. Adjust the steering cable. See “Jet thrust
nozzle steering angle check” (3-7).
Steering cable installation (jet pump
end)
1. Adjust the steering cable set length a,
and then tighten the locknut 1 to the
specified torque. (jet pump end)
Steering cable stopper bolt 3:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
1
2
3
a
4
5
Steering cable set length a (jet pump
end): 14.5 ± 1 mm (0.57 ± 0.04 in)
Steering cable locknut (jet pump end) 1:
7 N·m (0.7 kgf·m, 5.2 ft·lb)
a
1