Supplementary Manual

[THXM] THX Music
This preset is configured for DVD-Music production. Use this preset when mixing and/or
monitoring multi-channel music content (including DVD-Audio and SACD). Only one
parameter can be changed. The LFE gain (AMP) can be set to +10dB (default) or 0dB. Select
the level that complies with the standards of the target media. Please note: The LFE output gain
on some DVD players, receivers, and/or decoders may already be set to +10dB. Select the 0dB
setting only if the destination environment (home theatre, etc.) has the LFE gain set to 0dB.
Otherwise, use the default setting.
• MONITOR ALIGNMENT ATT & DLY ON/OFF
These buttons are used to turn on and off the Monitor Align-
ment Attenuator and Delay parameters of all Surround speak-
ers. The MONITOR ALIGNMENT diagram and Surround
Channel Attenuator and Delay parameters, which are dis-
played when either of these buttons are selected, allow you to
align the surround monitor speakers by attenuating and
delaying Surround Channels as necessary. The Attenuator
parameters can be set – ∞ , –12 dB to +12 dB in 0.1 dB steps. The Delay parameters can be set from
0 to 30 msec in 0.02 msec steps.
Note:
•Please note that the above settings apply only to the signals being monitored. They do not
affect the normal bus outputs.
•If you're monitoring in surround mode 6.1 and monitor matrix mode 6.1, you'll need to
make the above settings separately from when in other modes.
Tip: The settings you make here can be stored in the surround monitor library.