Supplementary Manual

ManualsBrandsYamaha ManualsDigital MixersYamaha 02R96 Version 2 V2.1

U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation

(4)

Movie LFE120Hz

This preset is the same as preset (2) mentioned above, except that the output level of surround

channels is set to –3 dB when the Monitor Matrix mode is 5.1 or 6.1. This preset is suitable for

movie production.

(5)

Bypass

Use this preset not only for bass management but to bypass all parameters, such as the LFE level

& LPF, surround channel level, etc.

To disable only the bass management, select another preset, then turn off the BASS MANAGE-

MENT ON/OFF button.

■

THX Presets:

The following presets have been approved by THX™ Ltd. for use in THX pm3™ Certiﬁed Stu-

dios*. They are designed to provide dedicated parameters for the proper playback of multi-

channel audio content in bass managed systems and to be compatible with subwoofer-satellite

type consumer systems.

*Use of a THX preset does not permit a studio to use the designation - THX pm3 Certiﬁed Studio.

The THX pm3 Studio Certiﬁcation Program uses performance and design speciﬁcations to create

calibrated environments for optimum sound and picture presentation. For more information,

visit the THX website at http://www.thx.com

[THXD]

THX DVD

This preset is conﬁgured for DVD-Video production. Use this preset when mixing and/or

monitoring audio content not from a theatrical ﬁlm source. The parameters cannot be

changed.

[THXF]

THX Film

This preset is conﬁgured for Film pre-production. Use this preset when mixing and/or moni-

toring theatrical ﬁlm-based content (such as a pre-mix for ﬁlm). The parameters cannot be

changed.

[THXM]

THX Music

This preset is conﬁgured for DVD-Music production. Use this preset when mixing and/or

monitoring multi-channel music content (including DVD-Audio and SACD). Only one

parameter can be changed. The LFE gain (AMP) can be set to +10dB (default) or 0dB. Select

the level that complies with the standards of the target media. Please note: The LFE output gain

on some DVD players, receivers, and/or decoders may already be set to +10dB. Select the 0dB

setting only if the destination environment (home theatre, etc.) has the LFE gain set to 0dB.

Otherwise, use the default setting.

• MONITOR ALIGNMENT ATT & DLY ON/OFF

These buttons are used to turn on and off the Monitor Align-

ment Attenuator and Delay parameters of all Surround speak-

ers. The MONITOR ALIGNMENT diagram and Surround

Channel Attenuator and Delay parameters, which are dis-

played when either of these buttons are selected, allow you to

align the surround monitor speakers by attenuating and

delaying Surround Channels as necessary. The Attenuator

parameters can be set –

∞

, –12 dB to +12 dB in 0.1 dB steps. The Delay parameters can be set from

0 to 30 msec in 0.02 msec steps.

Note:

•Please note that the above settings apply only to the signals being monitored. They do not

affect the normal bus outputs.

•If you're monitoring in surround mode 6.1 and monitor matrix mode 6.1, you'll need to

make the above settings separately from when in other modes.

Tip:

The settings you make here can be stored in the surround monitor library.