Owner's Manual

Information
for
Users
on
Collection
and
Disposal
of
Old
Equipment
This symbol on the products, packaging, and/or accompanying documents means that used
electrical and electronic products should not be mixed with general household waste.
For proper treatment, recovery and
recycling
of old products, please take them to applicable
collection points, in accordance with your national
legislation and the Directives 2002/96/EC.
By disposing of these products correctly, you will
help to save valuable resources and prevent any
potential negative effects on human health and the environment which could otherwise arise from
inappropriate waste handling.
For more information about collection and recycling of old products, please contact your
local
municipality, your waste disposal service
or
the point of sale where you purchased the items.
[For business users
in
the
European
Union]
If
you wish to discard electrical and electronic equipment, please contact your dealer
or
supplier for
further information.
[Information
on
Disposal in
other
Countries outside
the
European
Union]
This symbol is only valid in the European Union.
If
you wish to discard these items, please contact
your
local
authorities or dealer and ask for the correct method of disposal.
(weee_eu_en_01)
European
models
Purchaser/User Information specified in EN55103-1
and
EN55103-2.
Conforms
to
Environments: E1, E2,
E3
and
E4
•
Package
Contents
(Please
check
before
using)
---------
• Control panel unit
•
Plastic spacers (2; DCP1
V4S-EU
only)
•
Plastic cover
•
DCP1V4S-US/EU
Owner's
Manual (this
document)
• Installation
Procedure
-----------------
Lt.
CAUTION
Do
not
connect
control
panels
to
any
connector
other
than
the
[DCP] connector.
Doing
so
can result
in
damage
to
the
devices
or
even fire since
they
are
not
electrically compatible.
NOTE
•
Be
sure
to
switch
OFF
the
power
on
all host devices
before
connecting, since
the
host devices supply power
to
all
control panels.
•
Up
to
eight control panels
can
be
connected
to
each
MTX.
Refer
to
the
device's Owner's Manual
when
connecting a
device other
than
an
MTX
.
•
Make
sure that
each
control
panel
connected
to
the
same
MTX
has
a unique
Panel
ID.
0
Setthe
Panel I
D.
Set
each
PaneiiD
number
to
0-7,
using
DIP
switches
1-3
as
follows.
0
1 2
3
blblbl
Elblbl
blElbl
ElElbl
1 2 3 1 2 3 1 2 3
1 2 3
4
5
6
7
blblS
SblS blSS
sss
1 2 3 1 2 3 1 2 3 1 2 3
f)
Set
the
termination.
To terminate
the
last
control
panel
in a daisy-
chain connection,
turn
DIP
switch 4 (termination
switch)
ON.
Make
sure
to
turn
DIP
switch 4
OFF
for
the
other
control panels.
ON
BB
1 2
C)
Connect RJ-45
connectors
of
the
control
panel
and [DCP] connectors
of
the
host
device
using
Ethernet
cables.
E
thern
et cables can be connected
to
either
RJ-45
connector.
Use
CAT5e
or
higher
Ethernet
straight
cable
that
has
all
eight
pins connected.