User Manual

OUT CH VIEW (output channel view) function
115
OUT PATCHOUT INSERTOUT EQOUT COMPOUT DELAY
OUT DCA/MUTE
MATRIX/STOUT CH VIEW
4 EQ (equalizer)
This area displays the on/off status of the internal
EQ, the approximate response curve, and the peak
level of the signal that has passed through the EQ.
You can click the ON/OFF button to switch the EQ
on/off, or click the mini-graph to access the EQ
PARAMETER popup window.
5 COMP (compressor)
This area displays the on/off status of the internal
compressor, the approximate response curve, the
amount of gain reduction, and the peak level of the
signal that has passed through the compressor.
You can click the ON/OFF button to turn the com-
pressor on/off, or click the mini-graph to access the
COMP PARAMETER popup window.
6 TO ST (stereo pan)
This area displays the status of the ON/OFF button,
PRE/POST button, and PAN knob that are shown in
the MIX TO STEREO section of the MATRIX/ST
ROUTING screen (MATRIX/ST function).
You can also use the buttons and knob to modify the
settings.
7 DELAY
This area displays the on/off status and delay time of
the delay function.
You can also use the buttons and knobs to change the
setting. The upper numerical box always displays the
delay time in msec units. The lower numerical box
displays the delay time in the units currently selected
by the IN DELAY function.
8 TO MATRIX
This area displays the send level of the signal that is
sent from the currently selected channel to each
MATRIX bus, and the pairing status of the destina-
tion MATRIX bus.
You can also use the buttons and knobs to modify the
settings. To view MATRIX buses that are not visible
in the screen, use the scroll bar located at the right.
9 PRE FADER/POST FADE/POST ON
These buttons select the send point of the signal that
is sent from the currently selected channel to each
MATRIX bus.
0 ON/OFF
This button is an on/off switch for the signal that is
sent from the currently selected channel to each
MATRIX bus.
7
8
9
0