User Manual

Output functions
80
INSERT POINT
[Function]
For each output channel, switch insertion on/off, and select the insert I/O point.
■ Console
In the LCD FUNCTION ACCESS
block, press the OUTPUT [PATCH]
switch (press repeatedly until the
screen shown at the right appears)
■ Display
MENU button → OUTPUT PATCH
button → INSERT POINT tab
[Screen functions]
1 CH (output channel)
This shows the number of the output channel that
you are setting. For two channels that are a pair, this
area will display a heart symbol, and items 3–4 will
be common.
2 NAME
The short name assigned to each output channel is
displayed here. You can also click this area to assign a
short name/long name (→p.83).
3 INS. (insert on/off)
This button switches insertion on/off for each chan-
nel.
Before turning this button on, you must assign
input/output jacks to the insert out/in points in the
OUT PATCH function INSERT PATCH screen. Be
aware that if the INS. button for an output channel
is turned on when either the input or output jack is
unpatched, the correct signal will no longer be out-
put from that output channel.
4 INSERT I/O POINT
For each output channel, select the insert I/O point
(the location in the signal patch where the external
device will be inserted) from the following choices.
• PRE EQ .............. Immediately before the EQ
• PRE COMP
.........Immediately before the compressor
• PRE DELAY ....... Immediately before the delay
• PRE FADER....... Immediately before the fader
• POST ON........... Immediately after the [ON]
switch
1
32
4