User Manual

Global functions
44
SYS/W.CLOCK (system/word clock) function
Make settings related to system/word clock
SYSTEM CONNECTION
[Function]
Here you can check connections between units in the PM1D system. You can also select the operation mode
that determines the operation of the entire system.
■ Console
IN the LCD FUNCTION
ACCESS block, press the [SYS/
W.CLOCK] switch (press repeat-
edly until the screen shown at the
right appears)
■ DisplayDisplay
MENU button → SYS/
W.CLOCK button → SYSTEM
CONNECTION tab
[Screen functions]
1 OPERATION MODE
Specify the system configuration and connection
method of the console (CS1D) and engine (DSP1D-
EX {DSP1D}).
By clicking the button you can choose between
the following two modes.
Select the mode appropriate for the system configu-
ration or connections you are using.
• Console x 1 <–> Engine x 1
This is a system consisting of one console and one
engine.
If the engine is the DSP1D-EX, the system will oper-
ate with 96 monaural input channels. If the engine is
the DSP1D, the system will operate with 48 monau-
ral input channels.
• Console × 1 <–> Engine × 2 (Mirror Mode)
This is a system consisting of one console and two
engines in a mirrored connection.
In this mode, one of the two engines (A/B) performs
the actual signal processing, and the other is used as a
spare.
1