User Manual

124
Chapter 12. Internal effects
This chapter explains how to use the internal effects.
About the internal effects of the PM1D system
The PM1D system contains eight effect units. For each effect unit, you can select one of 29 effect types.
The inputs and outputs of these internal effects are not fixed to any particular bus or channel. They can be freely patched
to any output channel or input channel, or used as insert-in/insert-out in any channel.
• Signal flow for the internal effects
If the signal path is assigned to only one side of the effect, it will be processed as monaural input/stereo output.
• When the signal path is assigned to only one input
channel
If the signal path is assigned to both input channels, the
processing will depend on the type of effect that is cur-
rently selected. “STEREO type” effects process the L/R
input signals independently. “MIX type” effects mix the
L/R inputs before inputting them to the effect, and then
output in stereo.
• When the signal path is assigned to both input
channels
STEREO type effects
MIX type effects
MIX channels 1–48 output
OUTPUT PATCH
INPUT PATCH
Input channels 1–96 {1–48} input
EFFECT 1
MATRIX channels 1–24 output ST IN channels 1–8 {1–4} input
STEREO A/B channels output Input channels 1–96 {1–48} insert in
Input channels 1–96 {1–48} insert out
EFFECT 2
ST IN channels 1–8 {1–4} insert in
ST IN channels 1–8 {1–4} insert out
• • • • •
MIX channels 1–48 insert in
MIX channels 1–48 insert out MATRIX channels 1–24 insert in
EFFECT 8
MATRIX channels 1–24 insert out STEREO A/B channels insert in
STEREO A/B channels insert out
INPUT L R L RETURN
EFFECT
R RETURN
INPUT L or R
L RETURNINPUT L
EFFECT L
R RETURNINPUT R
EFFECT R
L RETURNINPUT L
EFFECT
R RETURNINPUT R