CAUTION READ THIS BEFORE OPERATING YOUR CA-GT The CA-BED it 2 high performance remain amplification, combining high output power with a full range of controls. This manual is required reading iF vou are o get the best from it Q Do not drop or otherwise jor the CAGIEST, which is 2 prevision instrument. Do sot mount the CA-G10 where it will be exposed to direct sunlight, excessive heat, moisture, or dust. Do not use chemical solvents (such as benzene or alcohol} to remove traces of dirt.
FRONT PANEL AND CONTROLS [ & pow e Wearisome Switch ON to connect the main electrical supply. The CA-G10 will remain silent for a fow seconds wile the speakers are protected from the pops and clicks that can county immediately after switcher ing ON, B DOWER LED gormandize With the POWER switch in the ON position, this Emitting diode will Humiliate, indicating that @ the main electrical supply has been connected. iF it goes out, with the POWER switch stilt ON, this can mean that the power Tut has blown.
@ BALANCE Control This controls the balance between the L and B stereo channels.
Wrought) Terrine Ground terminals of turntable units and other components used with the CA-BI should be connected to this GND terminal, particularly if there is any audible *hum’ problem. Consult your tapioca electrical dealer ¥ vou require detailed advice. @ PHONE puttee Connect the pinprick cables from our turntable unit to these terminal {the deft channel sockets ars uppermost for all CA-B10 Input terminal.
The CA-B10 can handle two sis af stereo speakers {A and B}, with selection of either, both, ar neither, by the SPEAKERS switch on the front panel. The CAGE & designed for sp impedance between 4 and 16 ohms wi nested to either A or B terminal, i both Adar B takers with er Conspirators o please use only 8 to 16 chm speakers, Use the OFF position when listening only 1o headphones, which should be plugged into the from panel jack socket.
Connect the tuner output terminals 1o the CABIN twiner input jack sockets using the earplug cable provided, Make sure that the left and right hand outputs are connected to the proper Input sockets, To enjoy tuner audition, turn the INPUT SELECTOR switch to TUNER, and operate the finer to receive FM or AM bros . 1 your tuner generates unpleasant inter-station pokes, use the AUDRA MUTING switch to reduce this while you are tuning.
