Quickstart Guide

Directions
Components
Quick Start Instructions
Installation Instructions
Door Marker
Outside Escutcheon
Inside Escutcheon Assembly:
• Inside Mounting Plate
• Inside Escutcheon
• Battery Cover
4 AA Alkaline Batteries
Bolt
Strike Plate
Screw Pack (7 screws)
1. Install bolt in door.
NOTE: The bolt must be in a retracted position
when installing the lockset.
Attach with two (2) M4 x 25.4mm screws
supplied.
2. Install strike plate on the door frame.
3. Route the cable through 2-1/8" diameter hole.
NOTE: Cable must go
under bolt and through.
See Detail A.
4. Insert outside escutcheon while routing cable
through inside mounting plate’s 1/2" hole; insert
mounting plate “tongue” into groove at bottom
of outside escutcheon.
5. Secure inside mounting plate to outside
assembly using (2) M6 x 59.5mm pan head
machine screws.
Do not over-tighten.
6. Attach cable assembly to the inside escutcheon
printed circuit board (See Detail B above).
CAUTION:
Use care when assembling to ensure that the
cable lies against the back recessed area of the
inside escutcheon.
Position and bend the cable, using the harness
clip as shown in Detail B to prevent binding when
installing the escutcheon over the mounting plate.
7. Slide inside escutcheon over mounting plate.
8. Install and secure using (3) M6 x 9.5mm
pan head machine screws through the
battery housing into the mounting plate.
9. Insert four (4) AA alkaline batteries.
The lock will flash, beep several times
and respond with the vocal prompt:
“Welcome to Yale Real Living”.
Note: Refer to programming instructions prior
to completion of step 10.
10. Install battery cover and tighten Phillips
head screw.
Tools Needed
 Phillips #2 screwdriver
 2-1/8" (54mm) hole saw
 1" (26mm) boring bit
 7/64" (2.5mm) drill bit
 Chisel & hammer
Yale Real Living
Touchscreen Deadbolt Quickstart Guide
An ASSA ABLOY Group brand
P/N AYRD220-INST-QUK Rev B
™
For Technical Assistance call Yale:
1-800-810-WIRE (9473)
4
3
Detail A
Inside Mounting Plate
Inside Mounting Plate
Inside Escutcheon
Outside Escutcheon
Battery Cover
5
7
8
10
Cable*
6
See Detail B
9
1
2
For more information go to: www.yalerealliving.com
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
(2) M6 x 59.5mm
[15/64 x 2-11/32"]
Pan Head Machine Screws
(3) M4 x 8mm
[8-32 x 5/16"]
Pan Head Screws
Harness
clip
Route cable as
indicated - do
not cover hole
Detail B
*Cable length exaggerated for illustrative purposes
UP