Installation Sheet

P/N - Rev AYE HLINSTL
4
Mark Jamb
6
Close door until latchbolt touches door jamb.
Mark latch and deadbolt top and bottom
edges as shown.
Using strike plates as templates, center plates
within the marks.
Trace outlines, inner holes, and screw holes of
strikes.
Note: Make sure strikes are aligned vertically.
Make sure strikes are aligned on
latchbolt and deadbolt.
Vertical
Centerline
of Jamb
Drill Holes and Install Strikes
7
Drill 1" (25mm) deep holes in door jamb for
bolts.
Chisel outline of strike plates 1/16" (1.6mm)
deep or until plates are flush with door jamb.
Drill pilot holes for screws.
Install strike plates with wood screws.
Note: Bolt holes must be 1" (25mm) deep for
proper lockset function.
Yale® and Yale Edge Series® are registered trademarks of Assa Abloy Residential Group. Other products' brand names
may be trademarks or registered trademarks of their respective owners and are mentioned for reference purposes only.
© Copyright 2018. All rights reserved. Reproduction in whole or in part without the express written permission of
Assa Abloy Residential Group is prohibited.
Product Support Tel [phone] • www.yalehome.com