Installation Sheet

P/N - Rev AYE HLINSTL
2
Mark Door
1
Use template enclosed to mark installation holes on
both sides of door.
Make mark for 1" (25mm) holes on door edge.
Note: Recommended height from floor 36"-38"
(914mm - 965mm).
Drill Holes
2
Drill 2-1/8" (54mm) holes about halfway through
door face, then finish drilling from other side to
prevent splintering.
Drill 1" (25mm) holes in center of door edge through
to 2-1/8" (54mm) holes for deadbolt and latch.
Drill 11/32" (9mm) hole for bottom of handle
mounting screw.
5-1/2"
(140mm)
8-13/32"
(213.5mm)
2"
(51mm)
3
Insert lower latch in hole, keeping it parallel to
edge of door.
Mark outline and remove latch.
Chisel 1/8" (3mm) deep or until latch face is
flush with door edge.
Note: Cutout must be parallel to edges of door.
Insert latch and mark screw holes. Remove
latch.
Drill pilot holes.
Insert latch and secure with wood screws.
Repeat procedure for upper deadbolt.
Install Latch and Deadbolt