Installation Sheet

P/N - Rev AYE DBINSTL
2
Mark Door
1
Fold and apply template to high edge of door bevel
and mark center of door edge as indicated on
template at desired height from floor.
Mark center hole on door face through guide on
template for either 2-3/8" (60mm) or 2-3/4" (70mm)
backset.
Drill Holes
2
Drill through door face as marked for deadlock.
Note: Drill holes from both sides to prevent splitting.
Hole size is 2-1/8" (54mm) for standard installations.
Drill 1" (25mm) hole in center of door edge through
to 2-1/8" (54mm) hole for latch.