Full Product Manual

P/N YRD226-MNL-0001 Rev I
23
1-3/8"* - 2" thick doors:
L = 3-1/2" (88.8mm)
2" - 2-1/4" thick doors:
L = 3-3/4" (95.3mm)
*Requires addition of Thin Door Kit.
L
W = .2" (5.2mm)
w
T
Tailpiece
T = .098" (2.5mm)
1. To Remove cylinder:
A. Remove outside escutcheon from door.
C. Insert small flathead screwdriver under spring.
Gently lift spring. Note: Notch on top of
cylinder engages spring.
2. To install new cylinder:
D. Remove cylinder by pulling outward towards
outside of door.
A. Reverse previous steps for removing cylinder.
Before installing cylinder, be sure tailpiece is
correct length (see below).
B. Remove rubber gasket.
C
Changing Lock: Replacing Cylinder
Resetting Lock to Factory Default
Reset
Button
Interior Lock
3. The reset button (see image at right) is located
beside the cable adapter.
Upon reset, Master Entry Code creation is the only
option available and must be performed prior to
any other programming of the lock.
4. While pressing the reset button (minimum of 3
seconds) reinstall batteries. Release reset
button.
5. Replace battery cover.
When lock is reset to factory defaults all user
codes (including the Master Entry code*) are
deleted and all programming features are reset to
original default settings (see below).
2. Remove the interior side of the lock to access
the reset button.
1. Remove the battery cover and batteries.