Operation Manual

Sleep Timer
The PIR features an automatic “sleep time” of
approximately 1 minute for power conservation.
After transmitting a detected motion, the PIR will
not retransmit for 1 minute. Any further motion
detected within this one-minute sleep period will
extend the sleep time by another minute.
LED indicator
Off Normal operation
LED flash
(2 sec)
When motion is detected and the
LED flashes for 2 seconds, this
indicates one of the following:
• Low battery
• Tamper switch activated
• PIR in test mode
WARNING:
When you delete the PIR Video Camera from
the system, please ensure the PIR batteries are
removed to avoid unnecessary drain.
Environmental conditions:
-10
o
c to 40
o
c , relative humidity 85%
non-condensing. Indoor use only
Radio:
2.4GHz
Motion Detection Range:
110
o
Specification
Operation
Note: Waste electrical products and batteries should not be disposed
of with household waste. Please recycle where facilities exist. Check
with your local authority or retailer for recycling advice.
Issue No. 1A
Information and illustrations are subject to change.
Yale reserves the right to alter the specification and
product design at any time without notice.