Operation Manual

Description:

1) Learn/Test Button with LED

Send test signal: hold and release within 3 secs.

This is used when checking accessory range

(See Smart Home Alarm user manual).

Send learn signal: hold for 10 secs+. Learn

button LED will ﬂash when learn signal is sent.

2) Camera Flash

3) Camera

4) 2 x 1.5V AA Alkaline batteries

5) Cover tamper switch

Pack contents

• 1 x PIR Image Camera with batteries

• 4 x wall plugs & screws

Program your PIR before installation and test

afterwards. Please see your current Smart Home

Alarm user manual.

SPECIAL NOTE:

When inserting new batteries, the following are

disabled for 5 minutes.

• Tamper Switch

• Image will not be sent in the ﬁrst 5 minutes

Please make sure you do not trigger the PIR

Video Camera for 5 minutes before testing the

system.

Compatible with Yale Smart Home Alarms

(SR-range) ONLY.

PIR Image Camera

(SR-PC)

smart

Living

Programming & Installation

For more information on this product

and Yale Smart Living Range visit

www.yale.co.uk/smart-living

Consumer Support: info@yale.co.uk

The 2 year guarantee for this

Yale Smart Home Alarm Kit is

active from the date of purchase

(A copy of this guarantee is

available on our website).

PAGE 1
smart Living PIR Image Camera (SR-PC) 1 4 2 5 3 Description: 1) Learn/Test Button with LED Send test signal: hold and release within 3 secs. This is used when checking accessory range (See Smart Home Alarm user manual). Send learn signal: hold for 10 secs+. Learn button LED will flash when learn signal is sent. 2) Camera Flash 3) Camera 4) 2 x 1.
PAGE 2
Operation Sleep Timer The PIR features an automatic “sleep time” of approximately 1 minute for power conservation. After transmitting a detected motion, the PIR will not retransmit for 1 minute. Any further motion detected within this one-minute sleep period will extend the sleep time by another minute.