Installation Sheet
5. Adjust lock for door thickness (if necessary).
A
B
2" door
1-3/4" door
C
2
Latch
Retractor engages
bolt tail(s)
Lockbody
Frame engages latchcase
Insert lockbody into door from outside making sure that
lockbody frame hooks latch case and retractor engages
bolt tail(s). DO NOT FORCE. (If lockbody does not
engage latch easily, check door preparation for errors.)
7. Install inside components.
8. Strike installation (Wood Frames Only).
A. Close door and mark a horizontal line from the center of
the template to the frame of the door.
B. Measure half the thickness of the door. Mark this same
distance with a vertical line starting from the stop side of
the frame and where both lines cross. Make a 1 inch
(26mm) diameter hole and 1/2 inch (13mm) in depth.
C. Align the holes of the strike with the vertical line. Trace the
outline of the strike and mortise with 1/16 inch (1.6mm)
depth. Attach the strike with two screws (provided).
STRIKES
371
Standard Strike Box
14-5301-1033
Attaching Screws
81-2012-0416
#8-8-32x3/4"
Attaching Screws
81-2012-0620
#12-12-24x1"
497
Optional Strike Box
#202
STOP
TEST THE OPERATION OF THE LOCKSET
Cycle the lock in both the locked and unlocked positions. If lock
functions smoothly when door is open, but binds when closed,
check door and frame alignment. If problems are found see
Troubleshooting on page 3.
6. Install lock.
A. Slide inside rose assembly onto lock body. NOTE: The
groove (see right) must line up with drive lug on spindle.
Fasten rose assembly with two thru bolts.
B. Place rose scalp on rose assembly.
C. Install lever handle. Snap in place, pull to insure properly
seated. (See Next Page For Double Cylinder)
Inside Lever
Handle
Through Bolts
Groove
(Align with
Lug on Spindle)
Inside Rose
Support Assembly
Rose Scalp
(Lock is packed preadjusted for 1-3/4" (44mm) doors. Available for 2-1/4" (57mm) doors upon request.)
To Adjust for Thicker Door
A. Remove two (2) screws from outside rose.
B. Slide outside rose away from lock body.
C. Adjust rose plate to desired door thickness per illustration at right.
D. Fasten outside rose to lock body with two (2) screws.
Slide plate
to disengage
2-1/4" door
An ASSA ABLOY Group brand
80-9150-0056-010 (01-13)