User Manual

Internal

Gate Application.

Step one.

• Remove Sahara from the box.

Step two

• Download the Yale Access App.

Step 3

• Scan the QR code on the Sahara an wireless DPS device that

will take you through the registration process of your device on

the Yale Access app and add the device to WiFi.

Step 4

• Hardware installation should now take place. The End user will

be taken through a step-by-step guide on the Yale access app

on how to install their Sahara, wireless DPS and magnet on a

generic Gate Automation device (See hardware installation part

to the right)

Step 5

• End user asked to test whether the device works after Sahara

hardware installation is done

Step 6

• Now end users can use Sahara to open or close their gate (See

example below).

Hardware installation.

Step one

• The end user is asked to power down their Gate Automation device in order

to avoid any electric interface and dangerous encounters.

Step two

• The end user should then take the wires coming out of the ‘NO’ (Normally

open), ‘Com1’ ports, and power supply ( 5V/ 24V) of the Sahara and connect

these to the relevant ports on a Gate Automation device. (As every

automation device has its own port locations, this connection method will be

shown to them through a wiring compatibility checker on the app and the

website)

Step three

• Once installed, the end user is asked to power up their Gate Automation

device if the LED light on the Sahara turns on then power is now available on

the device.

Step four

• The end user will be asked to power the wireless DPS and then attach it to

the gate door and take the magnet that comes with it and attach it to the

pillar of the gate which will allow the app to know the state of the gate.

Step Five

• This is an optional step for end users. If they have a ‘request for exit’ switch

inside their garage they can connect this to the rex1 or rex2 ports and so

then they can continue to open and close their garage through the switch

Wireless DPS