Operation Manual

Able to dial out but unable to make a proper connection

z Make sure that the network you are trying to connect supports the

Point-to-Point Protocol (PPP). Your ISP or network administrator can verify

this.

z Make sure that your dialing location is correct.

z Make sure that the phone number you are trying to reach is correct.

Modem connection is unreliable

z Make sure that the modem is installed properly.

z Make sure that the telephone line is connected correctly.

Network Connection Problems

z Make sure that the network card is compatible with your Yakumo deltaX 5

BT.

z Make sure that you have installed the proper drivers for your Yakumo

deltaX 5 BT.

z In the properties for your network card, make sure that you have correctly

configured the IP settings, and the addresses of your DNS servers and/or

WINS servers. Your network administrator can verify this.

z Make sure that you have added necessary server information.

z If Network Connection is not listed as a connection method in the ActiveSync

dialog box when starting synchronization, wait a few minutes and try again.

Also, if synchronization does not start right away, the network is probably

busy, and it may take a minute for your Yakumo deltaX 5 BT to connect to

the network.

z Verify with your network administrator that your user name and password

are correct.

z Verify with your network administrator that the network you are trying to

connect to is available, also try to connect to it from another computer.

z You may need to change the device name if you are trying to connect to a

network and cannot because another device with the same name is already