àx fxÜ

Fan Installation MQRB4436 / MQRB5143 / MQRB6961

SINGLE SIDED INSTALLATIONS:

Fan Kit should be installed before the fireplace is placed into wall cavity. To remove fan for service, the burner pan must

be removed and work done through the opening (See Burner System Removal section).

WARNING

Electrical Grounding

Instructions

This appliance is equipped with a

three prong (grounding) plug for

your protection against shock

hazard and should be plugged

directly into a properly grounded

three-prong receptacle. Do not cut

or remove the grounding prong

from this.

Before Servicing

1. Ensure all power supply is

shut off.

2. Label all wires prior to

disconnecting when servicing

control. Wiring errors can

cause improper and

dangerous operation.

3. For fan servicing: Vacuum and

clean lint/dirt build-up on the

fan blades and motor.

4. When resealing the Burner

Pan, use Millpac.

Fan Speed Control

(Locate Outside of

Fireplace)

Thermodisc

(Located under

Burner pan)

!NOTE: Do not allow any power

cords or wires to come into

contact with the firebox or the

underside of the burner pan.

NOTE: If Fan Mount Tabs are not present, place fan as shown and mount with screws. Thermodisc must be

mounted under burner pan. If no place is provided, mount with a screw from the valve bracket.