àx fxÜ

Recommendations for Finishing of Clean View Linear Products

 Only non-combustible materials may be used over the face of the appliance.

 We recommend that DUROCK (non-combustible material) be tied in to the entire perimeter of the fireplace for durability.

Finishing Recommendations (Obtained from professional construction contractors and finishers):

 Frame unit with metal studs (minimum 20 gauge).

 Minimum of 1/2” DUROCK cement board (this non-combustible panel is ULC listed as a wall shield/floor protector) and

fasten to the entire perimeter framing.

 Use fiberglass (mesh) tape for all joints in area of the fireplace.

 Use Yellow joint mud (contains high amounts of glue) – two coats, finishing with one coat of green topping mud, sand

and prep for painting.

 If not using a surround, a metal “L” Trim may be used to finish perimeter of DUROCK.

 Refer to the following website for more information on using DUROCK Cement Board: www.cgcinc.com