User's Manual

18.01.2011
YSOFT SAFEQ USB CARD READER V2 – ADMINISTRATOR’S GUIDE V1.1 [EN] 20/22
5 INFORMATION BEEP COD ES
Here is the list of beep codes, which give the result on the behavior of USB reader v2.
Legend:
- Long beep sound
. Short beep sound
 - Card read error. Please try placing the card again or use the different card.
 ...- Hardware configuration damaged cannot continue in booting.
 .-.- Update of firmware failed.
 --.- Software configuration cannot be saved. Probably faulty onboard eeprom.
 ..-- Software configuration damaged, loading defaults.
 .--- Firmware damaged.
 -... No reader connected and reader required for correct functionality.
 -.-. Service firmware damaged, re restore required.
 .--. Error in reader power-up sequence
Note: This option is available only if sound is enabled.