User's Manual

23.11.2009
YSQ TERMINAL PROFESSIONAL V3.5 – ADMINISTRATOR’S GUIDE V1.3 [EN] 10/20
4 TERMINAL SETTING
4.1 TERMINAL CONFIGURATION - COMMON
 if a DHCP server is to be used for configuring the terminal network settings, enable the use of DHCP;
 otherwise, set the IP address of the terminal, the subnet mask and default gateway and check that
DHCP is disabled;
 in both cases, set the SafeQ IP address of the server and the port number; note that this is not the port
of the web interface that you were asked for during installation but the TCP port on which the SafeQ
Server communicates with the terminals. By default its number is 4096
 When entering IP addresses in the various menu options, note that you must enter all three digits of
all the four numeric fields of the address. For example, to enter 192.168.0.37, you press the
192168000037 buttons on the on-screen keypad and then confirm with OK.
 When the required parameters have been set (or changed), push the "Save" button and exit the set-
tings. The terminal will restart and the new settings will take effect.
 When entering the data on screen manually, you should hear a beep with every registered touch.
Press the screen only until your depression causes a beep. Do not use greater force than necessary.
(The beeping may be turned off.)
4.2 ENTERING SERVICE MENU
After the boot up of terminal, the main menu will display (with the “Place card” message). To enter service
menu do the following:
1. touch the top left corner of the screen
2. touch the top right corner of the screen
3. touch the top left corner of the screen again
4. touch the top right corner of the screen again
5. a numerical keyboard should display. Press the 0 (zero) button four times and then press OK. A pre-
condition is that the default access code for the service menu (0000) has not been changed
6. the terminal service menu should now be displayed
If the terminal is configured to use PIN authentication only (no cards), the main menu will NOT be displayed
after the terminal boots up. In this case, enter 000000000 (nine zeroes) in the PIN entry screen, and then pro-
ceed with step 5 above.
The administrator is advised to change the default access code to the service menu (0000) to prevent users
from changing any of the settings.
Note: The procedure for entering into service menu described above corresponds to the service menu level 1
(site administrator level). Thereinafter in document there are screenshots relevant to service menu level 2 (all
the menu options) and therefore some options may be hidden when entering into service menu level 1.