User's Manual
USB Card Reader v3 Administrative Guide Product Sheet
2
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
.
埋込み型心臓ペースメーカーおよび埋込み型除細動器を装着されている場合は、本装
置または本装置のワイ ヤレスカードシステムのリーダライタ部(アンテナ部)から
12cm以上離れて携行および使用してください。 電波により埋込み型心臓ペースメー
カーおよび埋込み型除細動器の動作に影響を与える場合があります。
The product is in conformity with Directive 2002/96/EC of the European Parliament and
of the Council of 27 January 2003 on waste electrical and electronic equipment (WEEE) and
Directive 2003/108/EC of the European Parliament and of the Council of 8 December 2003
amending Directive 2002/96/EC on waste electrical and electronic equipment (WEEE).
Only for indoor use
2. Overview
System overview
YSoft SafeQ® USB Card Reader has following characteristics:
• Connection and power supply of the card reader via the USB host interface.
• Exchange of card reader possible without MFD turning off (hot-plug).