User's Manual

USB Card Reader v3 Administrator’s Guide
YSoft SafeQ 6
15 of 15
In the Linux OS the usage is similar with command:
./usbrdrtool -<parameter> <value> ...Usage:
Parameters:
-i input file (otherwise stdin)
-ooutput file (otherwise stdout)
-l list all configurable readers
-r select reader number to configure, if not specified then first reader will be used
-sselect serial number of reader to configure
-k reset the usb device after successful operation
-u update standard firmware (file on stdin or input file)
-w update service firmware (file on stdin or input file)
-j get log (data on stdout or output file)
-h this help screen
-v verbose operation
-t start card testing mode
6.6. Information BeeP codes
Here is the list of beep codes, which give the result on the behavior of USB reader v2/v3.
Legend:
- Long beep sound
. Short beep sound
Sound Behavior
- Card read error. Please try placing the card again or use the different
card.
...- Hardware configuration damaged cannot continue in booting
.-.- Update of firmware failed.
--.- Software configuration cannot be saved. Probably faulty onboard eeprom.
..-- Software configuration damaged, loading defaults.
.--- Firmware damaged.
-... No reader connected and reader required for correct functionality.
-.-. Service firmware damaged, re restore required.
.--. Error in reader power-up sequence.
Note: This option is available only if sound is enabled .