User's Manual

USB Card Reader v3 Administrator’s Guide
YSoft SafeQ 6
14 of 15
Linux:
sudo ./usbrdrtool -w -i usb2_service-1.0.1.fw --k
'-k' option will cause the new firmware to be booted after successful update.
Note: This command can be run form CMD windows or Linux, this is not a command inside the usbrdrtool.
6.4. Card reader settings for downloadeing the log files
For the configuration of USB card reader to downloading log files from the reader is possible to run following
command in the Windows command like (CMD) or on Linux OS:
Windows:
usbrdrtool.exe -j -o USBLOG.TXT
Picture 15 - Get log enabling
Linux:
sudo ./usbrdrtool -j -o USBLOG.TXT
Note: Please note that logging must be enabled before using this function
6.5. Card reader USBRDRTOOL starting with predefined commands
Administrator can start the USB card reader configuration with predefined usage. The pre-configuration list
is listed bellow as command lines parameters. For example write in cmd windows command line:
Picture 16 -Command line starting with pre-configuration