Product Sheet

USB Card Reader v3 Administrative Guide Product Sheet

Federal Communication Commission (FCC) Radiation Exposure Statement:

When using the product, maintain a distance of 20 cm from the body to ensure

compliance with RF exposure requirements.

FCC statements:

This device complies with part 15 of the FCC rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference

caused by unauthorized modifications or changes to this equipment. Such

modifications or changes could void the user’s authority to operate the

equipment.

NOTE: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

‐

Reorient or relocate the receiving antenna.

‐

Increase the separation between the equipment and receiver.

‐

Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

‐

Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

This device complies with Industry Canada’s licence-exempt RSSs. Operation is

subject to the following two conditions: (1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux

appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions

suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de

l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

125KHz ERP=56.718dBμV/m=0.001W, 13.56MHz ERP=32.445dBμV/m=0.001W

using distance:20cm