User's Manual

USB Card Reader v3 Administrator’s Guide
YSoft SafeQ 6
4 of 15
1. INTRODUCTION
1.1. PURPOSE OF DOCUMENT
This documentation provides essential information on installation and configuration of YSoft SafeQ® USB
Card Reader verison 3.
1.2. VALIDITY OF DOCUMENT
This document applies to YSoft SafeQ® USB Card Reader v3.
1.3. GOALS AND OBJECTIVES
The YSoft SafeQ® USB Card Reader v3 that could be simply connected to the multi-functional device and
serves for user authentication using card. Card must be assigned to any user in the YSoft SafeQ system.
After the successful authentication the user is able to manipulate with device and perform his print jobs,
copy jobs or scan jobs (depends on the device).
The YSoft SafeQ® USB Card Reader v3 could be also connected to workstations and can be used with the
credit charger application or with the SQ client for authentication.
1.4. TERMS AND ABBREVIATIONS
MFD - Multi-Functional Device
USB Card Reader v3 - YSoft SafeQ® USB Card Reader version 3
1.5. PREREQUISITE KNOWLEDGE
The person who installs USB Card Reader v3 must meet the following requirements:
knowledge of the YSoft SafeQ system (installation / administration / attendance)
knowledge of OS Win 2000, Win 2003 (installation / administration)
1.6. DISCLAIMER
The user that makes changes or modifications not expressly approved by the party responsible for
compliance (Y Soft Corporation a.s.) could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may
not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.