User's Manual

YSOFT SAFEQ TERMINAL PROFESSIONAL INSTALLATION AND ADMINISTRATION GUIDE 491
6 Performing diagnostics
This chapter describes diagnostics procedures available from the Diagnostics menu.
NOTE:
For information about testing the MFP control interface (also called the
"blocking cable”), see page 39.
Enabling Debug mode
In Debug mode, the terminal records error messages and other messages in a log. To
enable Debug mode and select which type of messages to log, follow these steps:
1 Display the Y Soft partners Service menu (see page 31).
2 Touch Diagnostic utils.
3 Touch Debug mode.
4 Select one of the following options:
No log – The terminal does not log any information.
Log errors – The terminal logs only error messages.
Log all messages – The terminal logs all messages.