Owner’s Manual Revolution 5 Blade Ceiling Fan Total fan weight KGS. LBS UL R WARNING : READ AND SAVE THESE INSTRUCTIONS. Follow these instructions carefully and be mindful of all warnings shown throughout.
READ AND SAVE THESE INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE FOLLOWING: 1. Use this unit only in manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number listed in warranty. 2. Before servicing or cleaning unit, or installing a light kit, switch power off at service panel and look service panel to prevent power from being switched on accidentally.
1.Unpack and inspect fan carefully to be certain all contents are included. Outlet Box Mounting Bracket O FF O FFO FF O FF 2.2. Turn off power at breaker box to avoid possible electrical shock. 3.3. 4.4. Install mounting bracket to outlet box in ceiling using washers and the screws provided with the outlet box. Use metal outlet box suitable for fan support. Secure outlet box directly to the building structure using ceiling joist screws (included). Outlet box must support 40 lbs min. 5.
Canopy set screw 5b-1. Yoke & Canopy Assembly Take off canopy decorating cap from bottom of canopy, then fasten 3 canopy set screws and washers provided from hardware bag onto yoke firmly. Washer Canopy Canopy decorating cap Fan assembly Mounting bracket 5b-2. Hanging the fan Tab Lift the fan assembly and hang onto the tab on mounting bracket. This will permit you to make the electrical connections without having to hold the fan up as well. 5c-1.
d. Canopy installation (1) Take off left-hand side screws ( one of each across ) on mounting bracket first, then loosen the other two. Push up the Canopy until the two screws on mounting bracket are engaged with L type slot holes on canopy. (2) Rotate the canopy slightly until the two screw heads are in the L type slot holes. (3) Tighten 4 screws firmly. Left-hand side screw Screws on mounting bracket 6.
