User manual

8.6 E-mail Servers
The Y-cam White can be configured to send an E-mail when the Motion Detection alarm is triggered or
It can send a snapshot after specified intervals.
The Y-cam can be configured with 4 different E-mail servers. These servers can be individually connected
to either send on motion detection or send periodically. (See section 8.3 and section 8.4 of this manual for further details)
[e-Mail server ID] Select the server ID. You can send up to four email servers.
[SMTP server name] Type the name or IP address of the SMTP server you want to use for sending the
e-Mails. Please note that some networks do not allow e-mail relaying. Check with
your system administrator or Internet service provider for more details.
[SMTP server port] The port number of the e-mail server (default is 25).
[Secure SSL Connection] Select whether your SMPT server requires an SSL connection.
[Authentication] Select whether authentication is required by the SMTP server.
[User name] & [Password] Type the user name and password of the e-mail account you wish to use
This field is required if your SMTP server requires authentication.
[Re-type password] Re-type the password.
[Sender e-mail address] Type the e-mail address of the account you are using to send the e-mail.
[Receiver e-mail address] Type the recipients’ e-mail addresses (Up to 3 address can be entered)
[Subject] Subject of the e-mail. Entering a relevant subject will help identify the alarm better.
[Message] Type the text you wish to appear in the e-mail.
.
Note:
These settings can be obtained from your e-mail service provider. Only POP3 e-mail is supported.
34