User manual

Obtain an IP address automatically(DHCP):

If your network supports a DHCP server (eg. router) select this option to have the IP address is assigned

automatically.

If you select Obtain an IP address automatically you should select Obtain a DNS Server address

automatically.

Use the following IP address:

Select this option when a fixed IP is required.

[IP address] Type the IP address of your camera

[Subnet mask] Type the subnet mask

[Default gateway] Type the default gateway

Always use the following DNS server address:

[Primary DNS IP address] Type the IP address of the primary DNS server

[Secondary DNS IP address] Type the IP address of the secondary DNS server, if necessary

HTTP port number

The default HTTP port number is 80.

[RTP port range] In order to view video over RTSP the router should be setup to forward port numbers

30000 to 30100 to the camera’s IP address using UDP with the internal port range of 30000 to 30100.

Refer to your router manual for further details.

Note: To obtain the addresses required please follow the procedure on page 13 of this manual.

The Y-cam White is set up to obtain the IP address automatically (DHCP) by default. Should you may wish to

assign the IP address manually, use the TCP/IP Setup page to enter the address details.

7.3 TCP/IP Setup