User manual

8.2 E-Mail Alarm Setup

The Y-cam Knight can be configured to send an E-mail when the Motion Detection alarm is triggered.

[Motion detection] Select Enable if you would like to receive e-Mail notification upon motion detection.

[Periodical send] Select Enable if you would like to the camera to send periodical e-Mails.

[Interval time] Type the interval at which you want to send the periodically e-Mails.

[SMTP server name] Type the name or IP address of the SMTP server you want to use for sending the

e-Mails. Please note that some networks do not allow e-mail relaying. Check with

your system administrator or Internet service provider for more details.

[SMTP server port] The default value is 25

[Authentication] Select the authentication required by the SMTP server.

[User name] & [Password] Type the user name and password of the e-mail account you wish to use

This field is required if your SMTP server requires authentication.

[Re-type password] Re-type the password.

[Sender e-mail address] Type the e-mail address of the account you are using to send the e-mail.

[Receiver e-mail address] Type the recipients’ e-mail addresses (Up to 3 address can be entered)

[Subject] Subject of the e-mail. Entering a relevant subject will help identify the alarm better.

[Message] Type the text you wish to appear in the e-mail.

[File attachment] Select if you would like a snapshot of the camera veiw attached to the e-mail or not.

Note:

The notifications use the Y-cam Knight’s internal clock. Please make sure the Y-cam Knight’s Date and Time are correct.

These settings can be obtained from your e-mail service provider. Only POP3 e-mail is supported.

[Secure SSL Connection] Select whether your SMPT server requires an SSL connection.