User's Manual

ADVANCED SETTINGS
Port Forwarding
The UPnP Setup of IP207W show a method of Port Forwarding（see page 24 for details），but some routers
maybe can’t support UPnP Port Forwarding, therefore, users need to configure Port Forwarding manually.
Firewall security features built into the router may prevent users from accessing the IP207W over the
Internet. The router connects to the Internet over a series of “ports”. The default ports used by the IP207W
are usually blocked from access over the Internet, therefore, these ports need to be made accessible. This
is achieved using the Port Forwarding function on the router. The ports used by the camera must be opened
through the router for remote access to your IP207W. Check your router’s user manual for specific
instructions on how to open and route ports on you router.
Important: Some ISPs block access to port 80 and other commonly used Internet ports. Check with your
ISP in order to open the appropriate ports. If your ISP does not pass traffic on port 80, you will need to
change the camera’s default port number from 80 to a different number such as 9000.
Viewing Your Camera
To access the IP207W from a computer on your local network, simply enter the IP Address of the Camera
followed by a colon and the camera’s port number. It is not necessary to enter the colon and port number if
you are using the camera’s default port 80.
To access the IP207W from the internet, type the external IP Address of the router, followed by a colon, and
the port number of your camera (e.g., Http://210.118.166.68:9000).
38