Operation Manual

SOFTWARE

This screen informs you about installed Software versions.

Operation buttons Setup Software

1. Source Tap to jump to Main Menu

2. Clock Time Shows Clock time

3. General Tap to enter general mode

4. Safety Tap to enter safety mode

5. Display Tap to enter display mode

6. Audio Tap to enter audio mode,

7. Software Tap to enter software mode, if not already active

8. Misc Tap to enter misc mode

Information ﬁ elds

9. Version Text Shows detailed software version information

SETUP MISC

Operation buttons Setup Misc

1. Source Tap to jump to Main Menu

2. Clock Time Shows Clock time

3. TFT Standby Tap to start TFT standby function

4. BT mic gain Tap to change microphone input gain

5. BT name order Tap to change the display sort order of the phonebook

6. Tuner Proﬁ le Tap to change tuner mode (stereo > mono)

7. General Tap to enter general mode

8. Safety Tap to enter safety mode

9. Display Tap to enter display mode

10. Audio Tap to enter audio mode

11. Software Tap to enter software mode

12. Misc Tap to enter misc mode, if not already active

13. Clock If no other setting is changed (3 ~ 6) you can tap the clock to set it manually*

*Note: setting the clock

XZENT has an integrated clock that will be automatically synchronized via RDS time signal. Sync is

performed only once on each device start and may require several minutes to show correct real time,

depending on the FM signal quality of the radio station you are listening to. This device uses a soft-

ware clock which is synchronized by GPS signal. The GPS sync’d time is used for route calculation.

4 5 76 8

8 9

1110 12

1 2 1 2