User Manual

4
PRODUCT FEATURES
◆ “3 in one” by design, saving working space, owning three function, can greatly
meet the users need.
◆ With special intelligent chip microcomputer control design, double LED display
operating by pressing keys, make it convenient and comfortable operation.
◆ Selection free for Fahrenheit and Centigrade (Celsius) temperature.
◆ “Password selection”: Temperature or air blow by digital display readout, easy to
read. The temperature can be locked by “password” code that is convenient for
production line management.
Soldering / Desoldering Function
◆ HEATER/SENSOR FAILED DETECTION: If sensor circuit failed that the
display reads “S--E” and cut off the heater power. If heater circuit failed the
display will read “H--E” and cut off the heater power.
◆ TEMPERATUE “LOCK-OUT” FEATURE: The temperature can be locked by
“password” code that is convenient for production line management.
◆ ESD SAFE AND SPIKE FREE CIRCUITRY: The “Zero Voltage” electronic
switching design also protects voltage and current sensitive components (CMOS
devices, etc.) against damaging current and transient voltage spikes commonly
produced by less efficient, mechanically switched stations.
◆ DELAYED SUCTION: To eliminate the problem of solder clogging up the tip, a
delayed switch feature has been incorporated for the unit that allows the pump to
continue sucking for 1.5 seconds after the actuator switch is released.
◆ LIGHTWEIGHT SOLDERING IRON: Ergonomic mini handle that stays cool
and prevents operator fatigue.
◆ ENERGY SAVER MODE: If the station has been idle for 20 minutes, the energy
saver feature will automatically engage, the temperature goes down to 150℃
from the set temperature. Activating the solder/desolder wands will disengage the
power saving feature and the unit will immediately ramp up to the preset
temperature. When over 40 minutes without operation the main power will be
switched off to “sleep mode” which cuts power consumption and extends tip life.
Please note: You have to turn off the power switch first and then switch “ON”
again to commence work when the unit goes to “Sleep” mode.
◆ IRON WORKING OPTION: When the users don’t use the soldering or
desoldering function ,or they also set by pressing keys “ SET + ▲”,at this time,