User Manual

3
● Do not aim the hot air at your eyes. Do not allow the hot air from the hand tool
to aim the eyes as serious eye damage may occur.
● The hot air pencil can produce a lot of heat. Do not allow the heater and the
nozzle to contact exposed skin as burning may occur. To eliminate the possibility
of burns, allow time for the equipment to cool before commencing maintenance.
● Death or serious injury may result from electric shock. It is therefore essential
to isolate the equipment from the mains before commencing repairs.
● Keep the hot air away from the body, clothes and flammable material when
in operation. The nozzle metal is in a high temperature status, do not touch the
nozzle! Always replace the hand tool to its original holder when not being use.
The nozzle and the heating element are still remaining hot after being switched off.
Ensure that you do not touch them.
● Do not block the air outlet in full area of the nozzle, or it may cause the heat
reflection and damage the heating element.
● Do not leave when the machine is on operating: Stare at the nozzle when the
rework station is on operating, so as not to burn your body or other objects. Turn
off the machine and unplug the power cord when you are leaving and put the hot
air handle to the holder in one side of the machine. The nozzle is still remaining
hot after being switch off on some time. Ensure that you do not touch the nozzle.
● Do not use if damaged: If the pump doesn’t work or the rework station becomes
faulty, discontinue using immediately. To comply with safety standards, the pump
or other part must only be replaced by authorized technicians as special purpose
tools are required. Only the technician is permitted undertake repairs. Use the
original replacement part only.
● Remember unplug in the power cord: The station must be switched off and the
power cord must be unplug-in before replacing the fuse in AC socket in rear side
of the machine.
● Do not unplug the power cord; when the power switch is turned off, the cooling
system will begin to work automatically, the temperature falls down to 100℃(212
℉) to protect the heater, remember that do not unplug the power cord at this time
until the unit stop working.