User Manual

amount of liquid detergent. Never submerse the unit in liquid or allow any liquid

to enter the station. Never use any solvent to clean the case.

9. This unit is designed for soldering/desoldering, hot air SMD rework and should

not be used for any other purpose without first consulting the manufacturer or its

authorized agent.

10. Keep the unit out of the reach of children. Young children should be supervised to

ensure that they do not play with the appliance.

To prevent electrical shock, be sure to take the following precautions:

1. Make sure the unit is grounded. Always connect power to a grounded receptacle.

2. Do not pressure the AC power cord. Be sure the work area is well ventilated.

3. Do not bump, hit, pour water/liquids or otherwise subject the heating surface to

physical shock. This may damage the heater.

4. To isolate the equipment from the mains before commencing repairs or making any

maintenance to avoid electric shock. This may result in Death or serious injury.

5. Do not expose the unit to moisture nor use the unit with wet hands.

6. Turn the power switch off and remove the AC power cord by pulling the plug (not

the cable) when the unit will remain unused for a longer period of time.

7. Do not modify the unit.

Warning

Soldering / Desoldering Function Warning

◆ Always place the soldering & desoldering irons in its original holder when not

being used.

◆ Keep the soldering and desoldering tip and heating element away from the body,

clothes and flammable material when in operation.

◆ The soldering and desoldering tip and the heating element are still remaining hot

after being switched off. Ensure that you do not touch the tips and the heating

elements.

◆ For your health, do not inhale solder fumes.

◆ You must not undertake work on live parts. Only the technician is permitted to

undertake repairs. Use the original replacement part only.

Hot Air Function Warning

● To last the life of the heating element, not recommend continuously using at

low air flow and high temperature. Let the heating element be cooler after using

a maximum 20 minutes. Ensure that it is placed back on its cooling stand to cool

down between rework operations. Also, do not switch the hand tool on while it is

in the cooling stand. Fail to comply with the instructions may result in damage

to the hand tool.