User Manual

11
Hot air function introduction
TEMPERATURE SETTING: (No password set)
1. Increase temperature: By pressing “▲” key one time, the digital will be increase
“1” numeral. If pressing “▲” key over 2 seconds then the digital numerals will be
forwarded counting continuously till the temperature up to what you desire to set.
2. Decrease temperature: By pressing“▼” key, the same procedure as above.
AIR FLOW SETTING: (No password set)
1. Increase temperature: By pressing “▲” key one time, the digital will be increase
“5” numeral. If pressing “▲” key over 2 seconds then the digital numerals will be
forwarded counting continuously till the temperature up to what you desire to set.
2. Decrease temperature: By pressing“▼” key, the same procedure as above.
PARAMETER SETTING:
1. Press “SET” key and hold for at least 3 seconds until display shows“— — —”
sign then release the “SET” key. The sign “— — —” starts to flash and reminding
the user to input the mode lock password “010” (fixed). If the user inputs the same
number as “010”, the unit will enter the modes selection procedure, otherwise, the
unit will be back from the current mode automatically.
2. After the unit enters the Modes selection, the LED will display “F-0”and flash.
Press “▲”or “▼” key to select modes. If the user doesn’t press “▲” or “▼” key
within 15 seconds or press “SET” key one time, then the unit will be immediately
back from the Parameter Set status.
For example: F-0 → F-1 → F-2
↑ ↓
← ← ←
3. Password Setting:
When the LED displays “F-1” and flashes, press “SET” key one time and the unit
enters the Password Set status. At this moment, the LED displays the pre-set value.
Press “▲” or “▼” key to change password set value. If the user sets “000” that
means the unit will be under the status of no password. If the user sets “100” then
means the unit will be under the password status. Press “SET” key once to finish
password setting and the unit will backup mode, the user can continue set other
modes or back from the setting mode.
4. Fahrenheit and Centigrade (Celsius) temperature selection
When temperature display window shows "F-4" and blinking, press the "SET"
button, at this time, the system enters the degrees Fahrenheit and Centigrade
temperature selection function, indicating the temperature of the window shows the
current status. Press "▲" or "▼" key to change the temperature selection status. It
expressed as degrees Celsius temperature value if set to ℃; it shows as degrees
Fahrenheit temperature if set to ℉.