Datasheet

ManualsBrandsXytronic ManualsFume ExtractionSolder Fume Extractor 340m³/h 50dB

- 1 -

INSTRUCTION MANUAL

FOR

HV-2 FUME EXTRATION

W/AIR FLOW CONTROL

Thanks for selecting Xytronic’s fume extraction system. All units are specially

designed and built in the highest standard and use only the best components. Please

read the instructions carefully to maximize the advantages of using your unit and we

believe you will be more satisfied with its efficiency of extraction and filtration.

Summary of content (5 pages)

PAGE 1
INSTRUCTION MANUAL FOR HV-2 FUME EXTRATION W/AIR FLOW CONTROL Thanks for selecting Xytronic’s fume extraction system. All units are specially designed and built in the highest standard and use only the best components. Please read the instructions carefully to maximize the advantages of using your unit and we believe you will be more satisfied with its efficiency of extraction and filtration.
PAGE 2
Important: Only the distributors authorized technicians can carry out component testing and replacement. Unauthorized replacement may result in a potentially dangerous situation and will invalidate the manufactures warranty. Please note if anything other than Xytronic replacement filters or parts are used that the manufactures warranty will also be invalidated. Do not operate the appliance with any damaged supply cord.
PAGE 3
Specification Type Voltage HV-2 100-120Vac 220-240Vac Frequency 60Hz 50Hz Current 1.2A 0.6A Rated Output Power 130W 120W Fuse T3.15A 340m ／hr Air Flow Range of Regulating Flow Noise Level Outline Dimension T2A 3 80%~100% < 50dB 310(L ) × 310(W ) × 460(H) mm Weight 20kg Setting Up 1. Unpack your new extraction system and ensure that the working voltage is the same as that of your electrical supply and truckles are lifted clear. 2.
PAGE 4
replace filter). * Eliminate alarm: Press the SET key to temporarily eliminate the buzzer alarm however the red LED will keep flashing. * Reset: Hold SET key while turning on the power, the timer will be reset condition (after releasing the SET key, the led and buzzer go off 3 times indication re-SET successful), and will automatically reset the timer.
PAGE 5
Fuse Replacement 1. Isolate the unit from mains power supply. 2. Use screwdriver point-blank press of fuse holder’s groove, and then counter-clockwise running, pull off press. 3. Putting out the press and fuse. 4. Installed the fuse that new and the same specification in to press. 5. Installed press with fuse put in fuse holder; use screwdriver clockwise turns on lathe into that.