Installation Guide

ManualsBrandsXylem ManualsBathSella 31-1/2 in. Vanity Cabinet Only in White

For customer support please visit www.xylem.biz or call 866 395 8112 weekdays 8:00 to 5:00 EST or fax 866 395 8113 any time

INSTALLATION INSTRUCTIONS

SELLA

VANITY

V-SELLA-80GR / WT

Rev 7/13

THANK YOU FOR CHOOSING XYLEM

Please take a few minutes to review this manual before you start installation. If you

encounter any installation problems, please don’t hesitate to contact us.

Before you begin, please observe all local building codes. Unpack the new product

and inspect for damage.

The appearance of your vanity may differ from the illustrations in this guide. This

instructions still apply.

Please ensure the finished wall is straight and plumb and the floor is flat and perpen-

dicular to the finished wall.

SUGGESTED TOOLS AND MATERIALS

sessalG ytefaS erusaeM epaTllirDleveL revirdwercS spilihP

10'

ROUGH-IN DIMENSIONS: WALL MOUNT APPLICATION

31.5" (800mm)

20.67" (525mm)

17.7" (450mm)

SUGGESTED HEIGHT:

Undermount Application:

13.25” (336.6mm)

Vessel Application:

7.25” (184mm)

FINISHED WALL

WALL-MOUNTED

BRACKET

(CONTRACTOR INSTALLED)

WALL-HANGING

BRACKET SYSTEM

6.8" (173mm)

13.7" (348mm)

PRE-MOUNTED

TO VANITY

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS TM SELLA TM VANITY V-SELLA-80GR / WT THANK YOU FOR CHOOSING XYLEM Please take a few minutes to review this manual before you start installation. If you encounter any installation problems, please don’t hesitate to contact us. Before you begin, please observe all local building codes. Unpack the new product and inspect for damage. The appearance of your vanity may differ from the illustrations in this guide. This instructions still apply.
PAGE 2
WALL PREPARATION Notch studs 1-1/2” (38mm) to provide support for brace 2x6 Brace Position of Bracket WALL BRACKET INSTALLATION WALL K UNLOC 2x6 Brace BRACKET Position of Brackets UNLOCK X2 For customer support please visit www.xylem.
PAGE 3
INSTALLATION INSTRUCTIONS WALL BRACKET K UNLOC PRE-INSTALLED CLIP * Pre-installed on vanity (left and right) • Position the vanity against the finished wall. • Insert vanity clip into outside rectangular slot and allow it to drop down until it is seated securely in the wall bracket. WALL BRACKET ADJUSTMENT For customer support please visit www.xylem.
PAGE 4
DRAWER ADJUSTMENT INSTRUCTIONS SIDE 2 1 2 1 CAM HEIGHT TILT CARE AND CLEANING • To maintain the beauty of the finish, avoid placing the furniture in direct sunlight, as sunlight causes fading. Also avoid extreme changes in temperature by arranging furniture away from radiators, heat and air vents, and air conditioning units. Avoid placing furniture directly under windows. • Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well aspolish it on a regular basis.